Device FSP not being saved
Posted: Sat May 06, 2023 5:16 am
Hi --
I'm running Madrix 5.5f. I have 4 SACN devices configured. I need them to run at 20FPS. I configured it in device manager. If configure 1 device, it makes all SACN devices same frame rate. That's fine. I save my Setup. Quit Madrix then load setup again. FPS defaults to 33.3. This is not ideal since I have Madrix set to load on boot then have the setup launch and start running a cue list.
Ideally configured FPS should be saved as part of the setup and loaded again. I've also tried saving the setup, but that doesn't do any good.
I'm running Madrix 5.5f. I have 4 SACN devices configured. I need them to run at 20FPS. I configured it in device manager. If configure 1 device, it makes all SACN devices same frame rate. That's fine. I save my Setup. Quit Madrix then load setup again. FPS defaults to 33.3. This is not ideal since I have Madrix set to load on boot then have the setup launch and start running a cue list.
Ideally configured FPS should be saved as part of the setup and loaded again. I've also tried saving the setup, but that doesn't do any good.